Tip: Ecoflow Reset

By 8 commentsCategory: Film, Tip, TroubleshootingTags: , , , , , ,

I had a weird couple days on set where my Ecoflow (River 2 Pro) would drop power for about a second when it was unplugged. The battery was fully charged.  After a bunch of searching of forums, I found an answer:

Unplug anything drawing power from the eco flow.  Press and hold the power button for ten seconds.

I’m not actually sure what kind of reset this is, because my eco flow kept all of the custom settings I put it, but the problem stopped.

Anyone else have either problems with an eco flow this has solved, or another solution to an eco flow problem?  Share in the comments!

8 comments

  1. Jonny Gilbert - Reply

    I have done that and when plug back in go’s back to overload how do I fix that please help

    • admin - Reply

      All I know is the one ecoflow reset trick. If it continues to overload- are you able to distribute your power draw across each outlet? How much power are you drawing?

  2. Fofirod - Reply

    Tengo una Ecoflow Delta 2, soy cubano, después de la desconexión de la electricidad (algo habitual en Cuba) olvidé desconectar el breaker general de la casa, no había electricidad en la ciudad, al conectar la ecoflow a la red de la casa me puso en el display (overload) como posible? No había electricidad, entonces dio error de duración de batería contra consumo, hizo algo? Esto es grave?

    • Mark LaPierre - Reply

      I’m only able to speak about my experience using these to make films, not to power households. So it’s very possible that you are attempting to draw too much electricity at once from the system. Unplug everything and plug one lower-draw item in and see it it works. If it does- I was right. For the error- I’m not a Delta technician, so I would look up the error code on the internet and see what it tells you. Very best of luck!

  3. Arelys - Reply

    Tengo problena el Ecoflow delta 2 se apago con carga y cuando lo encendi me marcó 00 en toda la pantalla toda las difracción en 0 lo e apagado por 10 minuto por 20 y no relaciona lo e puesto a la corriente y sigue con batería en p k puedo hacer

    • Mark LaPierre - Reply

      If you’ve already tried the tip I shared here, I’m not sure how to help. I’d contact their support center. I’ve had to have my Ecoflow replaced twice, which is frustrating.

  4. David - Reply

    Me llamo David, mi ecoflou delta 3 classic cuando la enciendo se apaga a los 2 segundo, no se qué hacer, tienen algún consejo?

Leave a Reply to Fofirod Cancel reply

Your email address will not be published. Required fields are marked *